Figure 92. Installing optional IDSDM/vFlash card
Next steps
1
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2
Follow the procedure listed in
After working inside your system
.
LOM riser card
Removing the LOM riser card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If installed,
4
If installed,
Steps
1
Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2
Release the two blue side plastic snaps holding the LOM riser card.
3
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable (SFP) are
clear of the slot in the back of the system.
Installing and removing system components
137