Figure 52. Installing the riser 1 module
Next steps
1
Install the butterfly module.
2
Install the top cover.
3
Follow the procedure listed in
After working inside your system
Network daughter card
Removing the network daughter card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
.
4
.
5
6
7
Steps
1
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2
Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
74
Installing and removing system components
Summary of Contents for DSS8440
