Figure 75. Removing the system board
Next step
1
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC MAC
address label of the replacement system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If you are replacing the system board, remove all the components that are listed in the
section.
Steps
1
Unpack the new system board assembly.
NOTE:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the chassis.
2
Holding the system board holder, lower the system board it into the system.
3
Incline the system board at an angle and align the connectors with the slots on the rear of the chassis.
4
Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
98
Installing and removing system components
