Steps
1
Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
System board jumpers and connectors
section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
Figure 58. Installing the MicroSD card
Next steps
1
Install the IDSDM or vFlash module.
2
Follow the procedure listed in the
After working inside your system
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
4
Remove the BOSS card.
NOTE:
The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1
Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2
Pull the M.2 SSD module to disconnect from the BOSS card connector.
84
Installing and removing system components
