V0505, 2.16
Move bend
In the graphical overview of the bendsequence, it is possible to change the order of bends sim-
ply by moving a bend to another place. Press the button ‘Move bend’ and the number of the
first bend is highlighted. Use the arrow keys to move this cursor to the bend that must be
moved. When the correct bend number is highlighted, press the enter key to select this bend.
Now use the arrow key to move the bend to the right place in the sequence. If the bend is on the
correct place, press 'enter' to confirm.
Swap Bends
With this command, two bends can change place in the bend sequence. Press the ‘swap bends’
button. Move the cursor to one of the required bends and press the ‘swap’ button or press enter.
Then move the cursor to the bend with which it must be swapped and press the enter key or the
‘swap’ button. Now the bends have been swapped. If for any reason the action must be can-
celled, press the softkey ‘abort swap’ during the procedure.
•
Restoring a bend sequence
A (partly) determined bend sequence is not automatically reset after leaving the bend sequence
menu.
After you re-enter the bend sequence menu it is possible to continue with the existing bend
sequence.
If you re-enter the bend sequence menu you have the following options:
2.q
Enlarge
Enlarge all bend pictures, thereby decreasing the number
of bends shown on the screen.
Reduce
Shrink the bend pictures, thereby increasing the number
of bends shown on the screen.
‘new’
start new bend sequence, the existing bend sequence is
reset
Function keys:
