12
TrioPure
TM
Sanitation System
DEL Ozone · San Luis Obispo, CA 93401 · USA · 800-676-1335 · Fax: 805-541-8459
Figure 12
Figure 13
Figure 14
Step 8 -
Look for bubbles of ozone in the water at the injec-
tor (found in the chlorinator cell). Install the flow meter at the
fitting going into the Chlorinator Cell. If there are no bubbles
at the injector, or only a small amount are being injected into
the water stream, or the flow ball on the flow meter does not
move to the proper position, go to
Trouble Shooting, Section
6A
for assistance.
Step 9 -
Turn
Chlorine Control
knob up about half
way (pointing straight up).
Step 10 -
Observe the
Chlorine Production
display; the display should come up to
5
.
Step 13 -
Check pool free chlorine levels every 24 hours, and
adjust
Chlorine Control
knob as necessary to get between
0.5 and 1.0 PPM.
Step 11 -
Turn
Chlorine Control
up until display just goes
to
10
.
Step 12 -
Turn off pool pump - verify that all indicators
remain green and that bubbles are still injected into salt
cell. (See
Figure 12, Step 8
).
Summary of Contents for TrioPure-25
Page 26: ......
