
Page 14
Gas connection
DANGER Risk of explosion or
poisoning by unprofessional
installation.
The appliance may be connected to
the gas distribution system only by a
registered LPG installer.
DANGER Risk of explosion!
Before starting any work on the gas
installation, please shut off the gas
supply.
•
Gas adjustment conditions and values are stated
on labels (or on type label).
Your appliance is adjusted for
LPG gas.
A stove without a flame failure device
may only be used with a free standing
cylinder placed adjacent to but not
closer to 300 mm to the stove.
Connecting the gas hose
•
Have your appliance connected so that it will be
close to the gas connection. Ensure that there is
no gas leakage.
•
Gas bottles should be located outdoors in a
suitable ventilated lock-up.
•
The connecting hose to be used must not be
longer than 200 cm in length.
•
Fit the clamp to the hose. Soak one end of the
hose (15 mm inner diameter) into hot water for 60
seconds to soften, then slip the softened end of
the hose completely onto the sharp hose tip of the
appliance.
•
Secure the hose by tightening the hose clamp.
•
Repeat the same procedure for the other end of
the hose by securing it to the regulator on the gas
bottle to complete the gas cylinder connection.
•
Always check for gas leaks after installation and
whenever a new or refilled gas bottle is used for
the first time.
Carry the appliance with at least two persons. The
appliance must be placed directly on the floor. It must
not be placed onto a base or a pedestal.
Material damage!
The door and/or handle must not
be used for lifting or moving the
appliance.
DANGER Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
DANGER Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected to the
mains supply only by an authorized
qualified person and the appliance is
only guaranteed after correct
installation.
DANGER
Risk of electric shock, short
circuit or fire by damage of the mains
lead! The mains lead must not be
clamped, bent or trapped or come into
contact with hot parts of the appliance. If
the mains lead is damaged, it must be
replaced by a qualified electrician.
Do not install the appliance next to
refrigerators or freezers. The heat
emitted by the appliance will lead to an
increased energy consumption of
cooling appliances.
Electrical installation
This appliance must be earthed and the manufacturer
and the seller do not accept responsibility for any
damage due to incorrect installation or electrical
connection.
This appliance must not be connected through an
earth leakage system.
Refer to S.A.N.S. 10142
Connection to the power supply
This appliance has a ‘Y’ type supply cord connection
and must be installed by a licensed electrician, who
will ensure that the stove is correctly connected and
safely earthed. The rated current is printed on the
serial number label attached to the stove upper back
panel.
The appliance must be connected to the mains
through an All pole isolating switch which has a
minimum clearance between the contacts of 3 mm. in
All poles. A means for disconnection must be
provided in the fixed wiring.
Gas regulator
Range – 2.8 KPA SA5 regulator with a 2 meter hose
and 2 hose clamps.