Defro Home VITAL 37S, Operating Manual

Page: 18 / 52

18
Increase to maximum flame height takes place after double
click of
button, what is confirmed with HI message.
7.7.6. TIMER
Timer operates in Manual, Thermostatic and Eco(nomy) mode.
Flame in the fireplace is damped after the set time has elapsed.
Maximum countdown time until damping is 9 hours and 50
minutes.
Timer switch on
Press and hold the button until an icon will appear on
the screen, and the hour field of the counter start flashing.
Use buttons to set hours of fireplace operation.
Confirm the setting with button. Minute field will start
flashing.
Set additional minutes using buttons. Confirm with
button.
Timer switch off
Press button, icon and counter will disappear from the
remote control screen and counting will be cancelled.
7.7.7. OPERATING MODES
The heater may operate in one of three modes (buttons activating
the given mode are red on the pictures):
Thermostatic mode is based on measurement of room
temperature where the heater is located and control of flame
height so as to maintain the temperature set in the controller.
Programmed mode is one of two programs set, which
specify when the heater should operate and what
temperature should be maintained.
Eco mode controls the fireplace so as to maintain the set
temperature, but in the more economical way. The controller
forces maximum height of the flame if the temperature is too
low. If the temperature is too high, then the minimum flame
will be set. One cycle lasts approx. 20 minutes.
7.7.8. THERMOSTATIC MODE
In thermostatic mode, ambient temperature is compared with a
thermostat temperature and the fireplace power is modulated
correspondingly to the difference of both temperatures. Ambient
temperature is measured by a sensor installed in the remote control,
therefore it should not be subjected to additional heat e.g. by exposing
it to the direct sunlight. If the temperature of the remote control exceeds
the ambient temperature, then measuring errors will cause cold spots
in the room.
Attention!!!
Do not store the remote control near the fireplace or in a place
exposed to sunlight.
Switch the mode on with button. A thermometer icon will
be displayed on the screen. Set temperature will be displayed
next to this icon for a while and then room temperature will
be shown.
Press and hold the button with thermometer until
thermometer icon starts flashing.
Set the temperature using buttons.
Confirm the temperature using button with thermometer.
The mode is switched off after you:
o
Press the button.