Defro Home VITAL 37S, Operating Manual

Page: 17 / 52

17
7.6.2. TIME SETTINGS
Press both buttons at the same time: .
Using or button select the number for the given day,
e.g. 1 - Monday, 2 - Tuesday etc.).
Confirm the day by simultaneous pressing of two buttons as
in item 1. Hour field will start flashing.
Select current hour using buttons .
Confirm selected hour by simultaneous pressing of both
buttons. Minutes field will start flashing.
Set the current minute using buttons. Confirm settings with
simultaneous pressing of both buttons or wait for a while.
7.7. PARENTAL LOCK
In parental lock mode only the switch off button is active.
Press both red buttons simultaneously to activate the lock.
Lock icon will be displayed
.
The lock is switched off by simultaneous pressing of both
buttons: and .
7.7.1. FIRING UP IN MANUAL MODE
Before manual ignition of the chimney initiated from the remote
control, please make sure that:
MANUAL knob on GV60 valve is in ON position (full rotation
- counterclockwise).
If the ON/OFF switch is part of the equipment, it should be
set to I(ON) position.
Press and hold the button (firing with one button) on
remote control or two button and at the same time
(firing up with two buttons) until two short audible signals will
be heard and an icon confirming the ignition will be flashing
on the display. Release the buttons.
The gas will flow to the primary burner after confirmation of
ignition.
Remote control automatically switches to manual control
mode.
7.7.2. STANDBY MODE
The equipment goes to standby mode after pressing and holding
the button, what results in damping of the primary burner and
maintaining the flame only in control burner.
7.7.3. FIREPLACE SHUTDOWN
Press the button to switch off the heater, what will be
confirmed by displaying the OFF text on the remote control
display.
Attention! Next firing up is possible when OFF stops flashing.
7.7.4. ADJUSTMENT OF FLAME HEIGHT
Press and hold button to increase flame height.
Press and hold button to decrease flame height.
7.7.5. ADJUSTMENT OF LIMIT HEIGHTS FOR THE FLAME
Remote control allows setting maximum or minimum height of the
flame.
Attention! Switch to minimum flame is preceded by its
instantaneous increase.
Double click the button to decrease the flame to
minimum height. Confirmation of executed operation is LO
text displayed on the screen.