2 4
| O A S I S P O L Y C A R B O N A T E V E R A N D A I N S T A L L A T I O N G U I D E
2 5
www.deponti.com
Patio Roof Manual – Type Bosco
28
935mm
980mm
17
18
6.5 Preparing and installing the roofing sheets
If you want to trim the width of the sheets, we recommend trimming off full ‘chambers’ whenever
possible so the edges remain sealed.
The roofing sheets have a top and a bottom. The UV side must face up. This is indicated with a
protective film on the sheets. Always place the correct side up.
1. Place the short condensation profiles (935 mm) at the wall end of the roofing sheets, where the
non-perforated anti-dust tape is located. Note: The tab of the profile must be on the bottom of the
sheet.
2. Place the long condensation profiles (980 mm) at the gutter end of the roofing sheets, where the
perforated anti-dust tape is located.
These condensation profiles have pre-drilled holes for drainage of the condensation water.
UV side up
If you want to trim the width of the sheets, we recommend trimming off full ‘chambers’ whenever possible so the edges
remain sealed. The roofing sheets have a top and a bottom. The UV side must face up. This is indicated with a protective film
on the sheets. Always place the correct side up.
1. Place the short condensation profiles (935mm) at the wall end of the roofing sheets, where the non-perforated anti-dust
tape is located.
Note: The tab of the profile must be on the bottom of the sheet.
2. Place the long condensation profiles (980mm) at the gutter end of the roofing sheets, where the perforated anti-dust tape is
located. These condensation profiles have pre-drilled holes for drainage of the condensation water.
6.5 PREPARING AND INSTALLING THE ROOFING SHEETS
6.5
Summary of Contents for OASIS POLYCARBONATE VERANDA
Page 35: ...3 5 DESIGN GRID ...
