In order to avoid the danger of an unexpected thermal circuit breaker
reset, this appliance must not be powered through an external switch,
such as a timer, or be connected to a circuit which is regularly switched on
and off by the electricity provider.
Separate the very low voltage cables from the 230/400 V power supply
cables.
Danger
Before any wiring work on the electrical circuit, switch off the
power supply, check that no voltage is present and secure the
circuit breaker with a circuit breaker lockout.
Before any work on the appliance, carefully read all documents that
accompany the product. These documents are also available on our
website. See the last page.
See also
Technical specifications, page 10
1.2
Recommendations
Important
Keep this document close to the place where the appliance is
installed.
Important
Allow the space required to correctly install the heat pump. Refer
to the Overall space needed for the heat pump section in the
installation and service manual.
Important
Only qualified professionals are authorised to assemble, connect,
commission and service the installation.
Caution
Remove the heat pump casing only to perform maintenance and
repair work. Always put the casing back in place after such work.
Important
Never remove or cover the data plates and labels affixed to the
heat pump.
The data plates and labels must be legible throughout the entire
lifetime of the heat pump. Immediately replace damaged or
illegible instructions and warning labels.
Warning
Do not bring the heating water and the domestic water into contact
with each other in the the heating system.
Caution
To enjoy warranty cover, no modifications must be made to the
heat pump.
Caution
The frost protection function does not work if the heat pump is
powered off.
1 Safety
6
GSHP
7611407 - v07 - 14022022
