DEC LA30N, User Manual

Page: 20 / 193

2-6
Paper Handling
Operation Required Conditions
*1
Required Action
Ready Printing
*2
Fault
Select a resident font — Not printing Off Press Font .
Enter Macro selection mode — Not printing Off Press Macro . ( M1 and M2
will turn blinking
alternately for 3 seconds.)
Select Macro 1 —
*4
Off Press
M1
within 3 seconds
after pressing
Macro
.
Select Macro 2 —
*4
Off Press M2 within 3 seconds
after pressing Macro .
Switch the protocol — Not printing
*4
Off Press Protocol .
Enter Top-of-Form Adjustment mode — Not printing Off Press
Set-Up/Quit
and
Top
.
Move paper by 1/60 inch Off — Off Press or button.
Use the adjustment temporarily Off — Off Press
Set-Up/Quit
.
Use the adjustment permanently Off — Off Press Exit/Save .
Clear the adjustment Off — Off Press
Top
.
Enter Set-Up mode N/A N/A N/A Turn power on while
pressing
Set-Up/Quit
.
Move cursor to select Off Not printing Off Press or button.
a Set-Up Function or Value
Move cursor to select Off Not printing Off Press or button.
a Set-Up Option
Select a Set-Up Function Off Not printing Off Press or button.
or Value
Select a Set-Up Value and Off Not printing Off Press Exit/Save .
move cursor to
SAVE&EXIT
Quit Set-Up mode without Off Not printing Off Press
Set-Up/Quit
.
saving values
Clear software-detected errors — — Blinking Press
Pause
.
Initialize the printer — — — Turn power off and on again.
*1 In Normal mode operation, all buttons except
Pause
are inactive in the Busy state in which the printer is receiving
or printing data.
*2 Not printing includes the following situations: the printer is ready and awaiting data, or the
Pause
button is
pressed and the printer is awaiting data, or the Pause button is pressed during printing.
*3 This operation is available in the rear-feeding push-tractor mode.
*4 Switching is not done if the printer is holding printing data.
#02 Chapter 2 23/05/96, 14:16 6