Dea REV Series, Operating Instructions Manual, Page: 9 / 26

26
6 STANDARD PROGRAMMING
1
Power Supply
Give power supply, the display shows the following symbols “ ”, “ ”, “ ” and then “----”.
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START
command is given, the position reset procedure is performed (see “rESP” in the table “WORKING STATUS MESSAGES” on page 31.
2
Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it’s correct);
Total operations counter (* see P064):
i.g.:
= 3x100* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.:
= 5*x500 = 2500 operations remaining
before the maintenance intervention request ( =
manoeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or
release the button to exit the parameter.
3
Selection type of operators
! IMPORTANT !
1. Scroll down the parameters with and keys until you vi-
sualise P028;
2. Access the parameter by pressing the key;
3. Verify that the value corresponds to d007 (REV), otherwise, you
must select it by pressing and keys;
4. Confirm your choice by pressing the key (display returns
again to P028).