Dea REV Series, Operating Instructions Manual

Page: 10 / 26

27
4
Selection of direction of motion
1. Scroll down the parameters with and keys
until you visualise P063;
2. Access the parameter by pressing the key;
3. Acting on and keys, set:
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the key (di-
splay returns again to P063).
Warning: The parameter automatically reverses
the motors output open/close and any limit switch
input open/close.
5
How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. confirm by pressing the key;
3. by pressing
(open) and (close), move the
leaf in the opening position and adjust the limit
switch cam so that it pushes the microswitch in
that point;
Repeat adjusting the closing limit switch.
4. Confirm by pressing the key (display shows
again P001).
6
Motor stroke learning
1. Make sure you have properly adjusted the opening/closing limit switches cams;
2. Scroll down the parameters with and keys until you visualise P003;
3. Access the parameter by pressing the key;
4. When “
” flashes, continue pressing the key;
5. Release the key when “ ” stops flashing; Start the learning procedure with operator 1 opening;
6. Wait for the door searches and stops on the opening stop and then on the closing stop.
7. Once the procedure is ended, the display will show “----“.
7
Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with and keys until you visualise
P027;
2. Confirm by pressing on the key;
3. Select the type of transmitter by scrolling and keys:
- d000=fix rolling-code ( suggested );
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the key (display shows again P027).
Warning: If you need to vary the type of encoding, and only if other
remotes with different encoding are memorized, you need to erase
memory (P004)
AFTER you have set the new encoding.