Dea REV Series, Operating Instructions Manual, Page: 2 / 26

19
REV
Electromechanical operators
for sliding gates
Operating instructions and warnings
Index
1 Warnings Summary 19 7 Advanced Programming 29
2 Product Description 20 8 Messages shown on the Display 31
3 Technical data 20 9 Start-up 31
4 Installation and Assembly 21
9.1
Installation Test 31
5 Electrical Connections
9.2
Unlocking and manual operation 31
5.1
Electrical Connections
for 24V models
22
10 Maintenance
32
5.2 Electrical Connections
for 230V models
24
11 Product Disposal
32
6 Standard Programming 26
Product Conformity
DEA System guarantees the conformity of the product to European Directives 2006/42/CE regarding “machinery safety”,
2004/108/CE “electromagnetic compatibility” and 2006/95/CE “low voltage electrical equipment”. See Declaration of Incorpo-
ration.
1 WARNINGS SUMMARY
Read these warnings carefully; failure to respect the following warnings may cause risk situations.
WARNING Using this product under unusual conditions not foreseen by the manufacturer can create situations of danger, and
for this reason all the conditions prescribed in these instructions must be respected.
WARNING DEA System reminds all users that the selection, positioning and installation of all materials and devices which make
up the complete automation system, must comply with the European Directives 2006/42/CE (Machinery Directive), 2004/108/CE
(electromagnetic compatibility), 2006/95/CE (low voltage electrical equipment). In order to ensure a suitable level of safety, besides
complying with local regulations, it is advisable to comply also with the above mentioned Directives in all extra European countries.
WARNING Under no circumstances must the product be used in explosive atmospheres or surroundings that may prove cor-
rosive and damage parts of the product.
WARNING To ensure an appropriate level of electrical safety always keep the 230V power supply cables apart (minimum 4mm
in the open or 1 mm through insulation) from low voltage cables (motors power supply, controls, electric locks, aerial and auxiliary
circuits power supply), and fasten the latter with appropriate clamps near the terminal boards.
WARNING All installation, maintenance, cleaning or repair operations on any part of the system must be performed exclusively
by qualified personnel with the power supply disconnected working in strict compliance with the electrical standards and regulations
in force in the nation of installation.
WARNING Using spare parts not indicated by DEA System and/or incorrect re-assembly can create risk to people, animals and
property and also damage the product. For this reason, always use only the parts indicated by DEA System and scrupulously follow
all assembly instructions.
WARNING Incorrect assessment of the impact forces can cause serious damage to people, animals or things. DEA System
reminds the installer must verify that the impact forces, measured as indicated by the standard EN 12445, are actually below the
limits set by the standard EN12453.
WARNING The compliance of the internal sensing obstacles device to requirements of EN12453 is guaranteed only if used
in conjunction with motors fitted with encoders.
WARNING Any external security devices used for compliance with the limits of impact forces must be conform to standard
EN12978.
WARNING In compliance with EU Directive 2002/96/EC on waste electrical and electronic equipment (WEEE), this electrical
product should not be treated as municipal mixed waste. Please dispose of the product and bring it to the collection for an ap-
propriate local municipal recycling.