- 5 -
Start-Up
Ensure that the main power line is plugged into the wall receptacle.
Turn on the Main Power Switch located at rear of the unit by switching it to the ON
position. (See Figure 5-2)
Figure 5-3. Front control panel (key on)
To activate the POLYLASE LP Laser:
Insert the laser key and rotate clockwise. (See Figure 5-3)
After the system is turned on and software self-test procedure is complete,
the Laser
Output Selection screen will be displayed.
Press corresponding button on the touch screen to select Alexandrite or Nd:YAG laser
output (see Fig. 5-3).
At this moment the cooling system pump will start and laser lamp(s) will ignite. After the
system has completed a start up cycle, laser will stay in
Edit
mode. In this mode laser
operating parameters can be modified by the operator and the laser energy can not be
emitted.
After the system is turned on, Parameter Settings stored in Memory #1 are used as default
operating parameters, until different parameters are selected by the user.
Key Switch
