page C16
DS-100C Operating Manual
unplugged before the battery is fully charged. This occurrence does not indicate
a fully charged battery.
Aux Charge Power & Fuse
The Aux Charge connector is a standard banana jack connector used to
recharge the battery from a DC power source such as a PV module. Do not
exceed the input voltage. A fuse protects the tracer from excess current.
RS-232 Serial Port
All DS-Tracer operations are controlled with commands sent to the DS-Tracer
through this serial port or the USB port. This port is a standard 9 pin RS-232
port. This port is configured as a DCE device. Normally the DS-Tracer functions
are controlled with the IVPC software, but you can create your own software
using the DS-Tracer command codes described in section 6.0 DS-100C
Additional Capabilities.
The DS-Tracer uses the following RS-232 format:
9600 Baud
No parity
8 data bits
1 stop bit
Main USB Port
All DS-Tracer operations are controlled with commands sent to the DS-Tracer
through this USB port or the RS-232 port. This port is a standard USB Type-B
port. Normally the DS-Tracer functions are controlled with the IVPC software, but
you can create your own software using the DS-Tracer command codes
described in section 6.0 DS-100C Additional Capabilities.
Aux USB Port
This port supports auxiliary DS-100C operations This port is a standard USB
Type-A port. This port is NOT used to control the DS-100C IV tracer. It is meant
Summary of Contents for DS-100c
Page 8: ......
