The Sigfox-Ready AC current sensor is a combination of a wireless transmitter and an AC current transducer.
Therefore, the installation will be divided into 02 parts:
Installation for the wireless transmitter: these steps are to make sure the device sends data successfully;
Installation for AC current circuit: these steps are to make sure the device to measure correctly.
Locate the place to mount the CT, the place that is to measure the load current;
Locate the place to mount the Wireless transmitter to get the best RF signal. As the AC current transducer will be
attached to the wireless transmitter, please make sure the cable length is enough for the distance from CT to the
wireless transmitter;
Mount the wireless transmitter on the wall or outside the wall of the electrical panel. The antenna part must be
higher than the highest point of the electrical panel. Then connect the grounding wire from the base of the
wireless transmitter (if available) to the grounding system of the facility. Please check this link for the
mounting
Please follow the orders of steps strictly as below.
1.5.1 Preparation of the locations
To get a strong RF signal please refer to
.
1.5.2 Wireless Transmitter Installation
