Davey microlene MCS, Installation And Operating Instructions Manual, Page: 4 / 24

4
Safety Considerations
Although your UV system has been manufactured to the highest safety standards,
care must be followed when operating and/or maintaining your system.
1. Please read the instructions.
- This appliance contains a UV-C emitter.
- Unintended use of the appliance or damage to the housing may result in the
escape of dangerous UV-C radiation. UV-C radiation may, even in little doses,
cause harm to the eyes and skin.
- The appliance must be disconnected from the supply before replacing
the UV-C emitter.
- The appliance is intended to be permanently connected to the water mains and not
connected by a hose-set.
2. Before servicing this equipment, disconnect the power cord from the
electrical outlet.
WARNING: Do not operate the UV-C emitter when it is removed from
the appliance enclosure.
3. Energy given off by the UV lamp is harmful to your eyes and skin.
NEVER look directly at an illuminated UV lamp without adequate eye
protection and always protect your skin from direct exposure to the UV light.
4. For complete disinfection, use ONLY genuine replacement parts.
5. The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction.
6. Children should be supervised so that they do not play with the appliance.
7. To avoid possible electrical shock, use only with a properly earthed
electrical outlet. Appliances that are obviously damaged must not be operated.
8. Never perform any maintenance to the system unless you are comfortable in
doing so. Contact the manufacturer for service instructions if required. Read
the maintenance instructions before opening the appliance.
9. Do not use this system for any purpose other than what it was intended for.
Misuse of this system could potentially cause harm to the user or others.
10. Your system is intended to be installed indoors and away from leaking plumbing.
DO NOT plug the unit in if the system or any of the components are wet.
The UV system should only be installed outdoors if a suitable covering has
been installed to prevent direct contact with the environment (Rain and/or
direct sunshine).
11. The appliance is to be supplied through a residual current device (RCD)
having a rated residual operating current not exceeding 30mA.
12. Maximum working voltage of built-n UV driver U-OUT-250V
13. Maximum operating pressure stated in the instruction manual is 827 kPa (120 psi).
14. We recommend that a licensed plumber or certified technician install the system.