Datex-Ohmeda CAPNOMAC ULTIMA, Service Manual

Page: 227 / 232

CAPNOMAC ULTIMA
TM
SERVICE MANUAL
12-9
B
GRAPHICS PRINTER
CKP- 124
The CKP- 124 Graphics Printer is a Kodak Diconix 180si printer to
be used with the DATEX-ENGSTROM monitors. Before using the
printer make sure that the printer settings are as follows, see
chapter Using the Printer Setup Menu in the User’s guide of the
printer.
(1)
Emulation
(2)
Page length
(3)
Perforation skip
(4)
Character set
(5)
Character Default
(6)
Carriage return
(7)
Line feed
(8)
Graphic Print Dir
(9)
LF/Graphic/Pitch mode
(10)
Protocol
(11)
Parity
(12)
Data length
(13)
Baud Rate (Stop bits)
= EPSON FX-85
= 12 inches
= Off
= USA
= Set1
= CR
= LF
= Bidirectional
= Normal
= RDY/BUSY
= None
= 8 bits
= 1200 (1)
CCP- 104
PBJ-124
The CCP-104 is an HP ThinkJet graphics printer. Earlier printers
(CCP-104-xx-00, see the type plate on the bottom of the unit)
require an isolated connecting cable (P/N 873152) to satisfy
medical electronics safety requirements. Newer printers (CCP- 104-
xx-01) are IEC 601- 1 class II devices and do not require an
isolated cable. The non-isolated connecting cable is P/N 875370.
Due to changes in printer cable connector design the isolated cable
P/N 873152 can not be connected to the new printers.
For troubleshooting the printer please refer to the HP ThinkJet
service manual. For troubleshooting the isolated connecting cable
please refer to the schematics and layout of the isolation box in
Figures B.l and B.2.
The PBJ-124 Graphics Printer is a Canon BJ-30 printer to be used
with the DATEX-ENGSTROM monitors. Note that the printer has
a Parallel Centronics interface and requires Printer Cable CC-SPC
for connecting to the serial port of the monitors.
When using PBJ- 124 the printer selection in User Configuration
menu must be “IBM-PRO”. The selection is available in main
softwares of level -4.0 and up.
For the Printer Setup see Ultima Operator’s Manual.
January 15th, 1997/6