EN
Dateq BCS70 Manual
BCS71(GE) dual mono input module
7
BCS71(GE) dual mono input module
BCS71
Mono module w ithout gain or tone control
BCS71E
Mono module w ithout gain, w ith tone control
BCS71G
Mono module w ith gain, w ithout tone control
BCS71GE
Mono module w ith gain and tone control
Mic / Line
Input selection. Sw itch pressed in is Line (LED lights
up).
Gain
Volume presetting (only on the BCS71G and
BCS71GE). Limited adjustment range: ± 12dB.
Low Cut
Low cut filter (20/80 Hz). Sw itch pressed in (LED
lights up) is active.
High
High tone control (only on the BCS71E and
BCS71GE). Shelving: ± 12dB @ 12kHz.
Mid
Mid tone control (only on the BCS71E and BCS71GE).
Bell curve: ± 16dB @ 1.3 kHz.
Low
Low tone control (only on the BCS71E and
BCS71GE). Shelving: ± 16dB @ 60 Hz.
AUX / AUD / PGM
Bus routing sw itches. The sw itch pressed in (LED
lights up) indicates that the signal is being routed
from the module to the bus concerned. AUX can be
set to PRE or POST fader w ith jumpers.
PAN
Panorama control. The signal is placed at the desired
position in the stereo image.
CUE
Monitoring. This button lights up green if the CUE
function on this module is active. The button lights up
red if an (external) mute is active.
Overload
This LED lights up if the signal level anyw here in the
module is too high and distortion can or does occur
(the limit is 6 dB under clip level).
Fader
100mm long volume control. Depending on the jumper
settings on the module, the volume on the AUX bus is
dependent (POST) or independent (PRE) of the
position of this fader.
ON / OFF
Sw itches w ith w hich the channel can be turned on
and off (if button start w as configured) and/or the
equipment connected can be started / stopped. The
lamps in the sw itches can light up dependent on the
channel status (internal tally) or can be controlled by
connected equipment (external tally).
