EN
Dateq BCS70 Manual
BCS72(GE) dual stereo input module
10
BCS72(GE) dual stereo input module
BCS72
Stereo module w ithout gain or tone control
BCS72E
Stereo module w ithout gain, w ith tone control
BCS72G
Stereo module w ith gain, w ithout tone control
BCS72GE
Stereo module w ith gain and tone control
Line 1 / Line 2
Input selection. Sw itch pushed in (LED is lit up) is
Line 2.
Gain
Volume presetting (only on the BCS72G and
BCS72GE). Limited adjustment range: ± 12dB.
Mono
Makes the stereo input signal mono. Sw itch pushed
in (LED lit up) is active.
High
High tone control (only on the BCS72E and
BCS72GE). Shelving: ± 12db @ 12 kHz.
Mid
Mid-tone control (only on the BCS72E and
BCS72GE). Bell curve: ± 16dB @ 1.3 kHz.
Low
Low tone control (only on the BCS72E and
BCS72GE). Shelving: ± 16dB @ 60 Hz.
AUX / AUD / PGM
Bus routing sw itches. Sw itch pushed in (LED lit up)
indicates that the signal is being routed from the
module to the bus concerned. AUX can be set to PRE
or POST fader w ith jumpers.
BAL
Balance control. This is used to set the balance
betw een the left and right channels.
CUE
Monitoring. This button lights up green if the CUE
function on this module is active. The button lights up
red if an (external) mute is active.
Overload
This LED lights up if the signal level anyw here in the
module is too high and if distortion can or does occur
(the limit is at 6 dB under clip level).
Fader
100 mm long volume control. Depending on the
jumper settings on the module, the volume is
dependent on the AUX bus (POST) or independent
(PRE) of the position of this fader.
ON / OFF
Sw itches w ith w hich the channel can be turned on
and off (if button start is configured) and/or the
connected equipment can be started / stopped. The
lamps in the sw itches can light up dependent on the
channel status (internal tally) or can be controlled by
connected equipment (external tally).
