1 DATECS
LP-50
40
4.4. Working with forms
Starting to save a new form
This command starts the entry of a new form in the operational
memory of the printer. All valid commands, which are sent to
the printer between this command and FE will be saved in this
form. If any of the commands is rejected due to syntax error
because it has not been accepted in a form it will not be saved.
If there is a previous form with this name it must be deleted with
FK - in the opposite case the command will be rejected.
Format:
FS”Name”
Name is the name of the file, which have at the most 8 s
are acceptable excluding the symbol ‘*’. Small and
capital letters are not distinguished so that “Test” and
“TEST” are one and the same form.
Example:
FS”Test”
End of form
The command puts an end to the saving of the form it is
registered in the list of forms and is ready for loading and
execution. If before the command FE the printer is switched
OFF the information from the form entered so far is lost and
the memory space it has covered is set free. If no saving of a
form is started the command will be rejected.
Format:
F E
