Datcon DT9500, Operating Instructions Manual

Page: 73 / 100

DT9500
20220103-V2
73
10.6. Messages and error messages during setting up

The following mnemonics may displayed when the settings
are being performed.

The value you have defined is lower than permissible
( Lo w Li mit)
The instrument has replaced the value you have defined to
the permitted lowest value.

The value you have defined is higher than permissible
( Hi gh Li mit)
The instrument has replaced the value you have defined to
the permitted highest value.
.

Exit from the menu, returning to the normal operating
mode
( Exit )

Saving the changed parameters is being done ( Save )

(4 lines at the bottom of
the display)
Low numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit” to the display
format.

(4 lines at the top of the
display) 
High numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit” to the display
format.

The instrument is performing internal operations
( Busy )

The requested task has been successfully completed
( Re a dy )

The device is preparing for the measurement.

I do not want this menu item ( No )

Yes, the menu item may be started (Yes)