Datcon DT9500, Operating Instructions Manual

Page: 63 / 100

DT9500
20220103-V2
63
7.17. Resetting the default settings (15. menu item)
Function In this case all the settings are deleted, and the default
factory setting is restored.
Using this function makes sense in that case, when the
settings of the instrument have changed so much, that it is
easier to start the setting-up process from the default
factory setting.
It is not possible to cancel this operation once the
command has been issued.
Sequence of operations 1. Enter the menu by typing the supervisor code.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see this on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:

.
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic

is shown on the display. The
mnemonic is blinking.
Now you still have the possibility to exit. If you want to exit,
as you do not want to reset the default settings after all,
press the
MENU button. This takes you out from this menu
item, and you see this:

.
5. If you want to reset the default settings, press the ▲
button to change the „NO” to „YES”.
•


= I do not want to reset the default settings
•


= I want to reset the default settings
6. Press the MENU button.
The instrument displays the mnemonic

(busy), then
the mnemonic

(ready). After then it restarts:

,

.
According to the factory settings, it measures the loop
current with a resolution of three decimals.