Datcon DT9500, Operating Instructions Manual

Page: 58 / 100

DT9500
58
20220103-V2
7.14. Display operating modes (12. menu item)
Function The instrument has a 4-and-a-half-digit display. It is
possible to switch it into a 3-and-a-half-digit display mode.
In this case the display behaves like a 3-and-a-half-digit
display during measurement. (The mnemonics are
displayed in four digits).
[Default factory setting: four-and-a-half-digit operating
mode.]
Sequence of operations 1. Enter the menu by typing a supervisor code.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:

.
3. Enter the menu item by pressing the ENTER button.
4. You see this

on the display. The mnemonic is
blinking.
5. You may switch between the two operating modes by
pressing
▲ button.
•


= four-and-a-half-digit operating mode [Default
factory setting]
•


= three-and-a-half-digit operating mode
In the three-and-a-half-digit operating mode the possible
range of numbers to display is reduced to the values being
between -200.0 and 200.0.
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
from the menu item, and you see this:

.
(2. If you want to change the setting you have performed
just now, or if you just want to check what you have typed
in, continue the operation from
Point 3 of the Sequence
of operations. )
(3. If you do not want to exit from the menu, as you want to
perform further settings, you may press the
▲ button to
select the desired menu items.)