DT4120 xx xx (PS)
16
20170324-V0
5.4. Connecting the limit relay outputs (option).
The following figure shows the wiring plan, connecting the
limit relay outputs:
Wiring plan, connecting
the limit relay outputs
(see also “Application
example”)
The push-in direct connector assemblies used allow a fast
connection of the cables.
Follow the next steps:
1. Push the stripped cable-end until it possible into the
terminal assembly. In the case of flexible cable-ends, you
can facilitate opening the connection part by pushing down
the white button.
2. By pushing the wire in, the self-closing connection is
being established. Check it by pulling it outwards firmly.
(3. When you are going to disassemble the cable, push
down the white button by a screwdriver, and pull the cable-
end out.)
The button can be pushed down easily. Please do not
exercise forces higher than necessary, as it may cause
damages to the terminal assembly.
Summary of Contents for DT4120 Series
