Datcon DT1310 Series, Operating Instructions Manual, Page: 37 / 52

DT1310 xx xx
20220128-V0
37
9. Dismounting
9.1. Dismounting procedure
The following figure shows the dismounting procedures:
Dismounting from the
rail
The dismounting procedure needs a screwdriver for slotted
screws.
1. Before dismounting disconnect all wires.
2. Put the screwdriver end into the fixing assembly’s hole
(figure step 1.).
3. Lift the screwdriver handle until it possible to open the
fixing assembly (figure step 2.).
4. Keeping the screwdriver in this position lift the
instrument bottom from the bottom edge of the rail (figure
step 3.).
Lift the whole instrument (you may put out the screwdriver)
(figure step 4), the instrument will be free.