Datcon DT1310 Series, Operating Instructions Manual

Page: 14 / 52

DT1310 xx xx
14
20220128-V0
5. Connecting
5.1. Preparing the connection
Select and prepare
connection cable
Always observe the following safety instructions:
•
The connection must be carried out by trained and
authorized personnel only!
•
Connect only in the complete absence of supply voltage
•
Use only a screwdriver with appropriate head
Take note the suitability of the connecting cable
(wire cross-section, insulation, etc.).
The wire cross-section should be 0.25-1.5 mm
2
.
You may use either solid conductor or flexible conductor.
In case of using flexible conductor use crimped wire end.
For the input connection we recommended to use screened
cable. It’s an important rule that the power cables and
signal cables should lead on a separate way.