4209-00009-000 EasyRead (DSV3-EP) User’s Manual
Rev 0E
6/29/2009
38
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
15.2
Docking Station I/O
The docking station provides access to the wired I/O ports of the DSV3 mobile terminal. Shown below is
a photo of the bottom of the docking station depicting the location of each of the I/O connectors. Cables
are normally routed through the cable trough in the back of the docking station. There is a cable tie
anchor point that can be used to secure the cables.
16
Troubleshooting
P
ROBLEM
P
OSSIBLE REASON AND REMEDY
Unit does not power up
•
The battery may be completely discharged (or may not be
installed).
•
Open the battery access cover and verify that the battery is
properly installed.
•
Use the external AC power adapter to operate the unit and to
simultaneously charge the battery.
•
Please refer to Section 4.12 “Battery Charging and Replacement”
The Power Status LED
turns red when the power
button is held down and
the unit does not power
up.
•
This is an indication that the internal battery is very low, and does
not have sufficient charge to run the unit.
•
Plug in the AC power adapter to charge the battery AS SOON AS
POSSIBLE.
•
Please refer to sections 4.2
Error! Reference source not found.
and 4.3 for Power button, LED indicator, and tone operation.
USB Host (x2)
Ethernet
USB Client
RS-232
12V Power
Input
Cable Tie
Anchor Point
Security Cable Loop
Cable Routing
Trough
