4209-00009-000 EasyRead (DSV3-EP) User’s Manual
Rev 0E
6/29/2009
34
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
³ 9 9 9 9 4 0
FSUSB Keybd Internal
12.3.2.1
Changing the Operating Mode from Virtual Com Mode to HID Mode
If the scanner is in Virtual Com mode, it can be re-configured for HID mode by using the following steps:
•
Launch the
DsCamerScannerEPTest.exe
application
•
Copy and cut out the linear bar code below so it can be inserted and scanned by the terminal.
•
To initiate a scan operation, press
F2
and hold it down until you hear a confirmation beep
(signifying that the barcode was scanned and decoded).
•
You will then hear 2 beeps and the scanner will reboot itself after ~8 seconds. You then hear 3
more beeps.
•
You should now be in HID keyboard emulation mode with the default settings, (run
DsCamerScannerHIDTest.exe
to verify this.)
12.3.2.2
Changing the Operating
12.3.2.3
Mode from HID Mode to Virtual Com Mode
If the scanner is in HID mode, it can be re-configured for Virtual Com mode by using the following steps:
•
Launch the
DsCamerScannerHIDTest.exe
application
•
Copy and cut out the three bar codes shown below so that they can be inserted and scanned by the
terminal. Scan each of the bar codes sequentially as described below.
•
To initiate a scan operation, press
F2
and hold it down until you hear a confirmation beep
(signifying that the barcode was scanned and decoded).
§
Scan the top barcode. You should hear 3 beeps.
§
Scan the middle barcode. You should hear 1 beep.
§
Scan the bottom barcode. You should hear 3 beeps.
•
The scanner will reboot itself after ~8 seconds. You should then hear 3 more beeps.
•
You should now be in Virtual Com mode with the default settings, (run
DsCamerScannerEPTest.exe
to verify this.)