4209-00009-000 EasyRead (DSV3-EP) User’s Manual
Rev 0E
6/29/2009
37
Copyright © 2009 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
15.1
Adjusting the Docking Station Backrest
The DSV3 docking station has an adjustable backrest. It is important
to adjust the backrest correctly to ensure proper operation. There is a
forward position (for use with the EasyVerify), and a rear position (for
use with the EasyRead). To change the position of the backrest
support, remove the 2 Philips-head screws in the plastic backrest
support, repositioning the backrest support to the appropriate position,
and then re-tighten the screws.
•
Forward Position
: This position should be used for
EasyVerify (DSV3-SP).
•
Rear Position
: This position should be used for EasyRead
(DSV3-EP)
Once the backrest is installed in the correct forward or rear position, the adjustment plunger may be
adjusted to accommodate any installed optional peripherals. The height of the adjustment plunger can be
adjusted by pulling it up or pushing it down to best support the specific configuration of the terminal.
There are detents in the mechanism to maintain the selected height. Once the plunger height is adjusted,
place the mobile terminal in the docking station. The adjustment plunger may need to be retracted (turned
counter clockwise) for the unit to fit. With the terminal resting in the docking station, the adjustment
plunger should then be extended (turned clockwise) until it just touches the back of the terminal.
To use the optical scanner on the EasyRead (DSV3-EP) while it is
docked, the adjustment plunger may be removed as shown in the
adjacent picture. The plunger is removed by pulling it upward
until is separates from the backrest support.
EasyRead (DSV3-EP)
EasyVerify (DSV3-SP)
Screws
Adjustment Plunger
Backrest
Support
