Datamax W-Class, Maintenance Manual

Page: 54 / 211

Troubleshooting
3-2
Warning Messages
Displayed Message Description Possible Solution(s)

The scheduled printhead
cleaning distance has been
reached. Press and hold the TEST Key, or select
‘CLEAN HEAD NOW’. See Section 2.4.1
for details.

The host has pending
configuration changes that
will not take effect until a
‘host reset command’ is
issued. To save the changes, send a host reset
command (in DPL). To discard the changes,
perform a soft reset; see Section 2.7 for
details.

The 24 VDC line has
dipped below the
threshold value. Possible low or fluctuating line voltage
level. Verify this condition with a voltage
measurement. If this condition persists, try
moving the printer to another outlet circuit.
Other possible causes include a faulty
power supply, main logic board, or
printhead.

The printer was unable to
save settings in permanent
memory. If the condition persists, possible faulty
main logic board; see Section 4.10.

A high printhead
temperature has been
detected. Allow the printhead time to cool.