2
PrintPAD CN70/70e USER'S GUIDE
Installing and/or Replacing Batteries
1. Open the printer by unsnapping the latch on the front of the case (Figure 1).
2. Lift the battery cover up by pushing the retainer clip inward with your finger (Figure 2).
3. Lift up the outside end of the battery to remove it.
4. Insert the new batteries. Verify the battery contacts are facing down and are facing the outside edge of the printer
(Figure 3).
5. Close the battery cover by snapping it into place.
Charging the Batteries and Handheld Computer
If the battery is low when the printer “wakes up,” the printer sounds three short beeps.
1. Remove the red battery isolator labels, if necessary.
2. Plug the power supply connector into the printer's external DC port. The DC port is located on the side of the
printer's case (Figure 4).
3. Plug the adapter in an appropriate power source.
Figure 1
Figure 2
Figure 3
Contacts
Figure 4
DC power port
(Input Voltage: 12V 1.5A MIN)
DEX/UCS port
Summary of Contents for PrintPAD 1700
