67
SERIAL PORT C
When equipped with a GPIO Card, this controls the RS-232
communications settings for the COM C (J4) port, as follows:
BAUD RATE
Sets the serial communication rate:
1200 BPS
1200 bits per second
2400 BPS
2400 bits per second
4800 BPS
4800 bits per second
9600 BPS
9600 bits per second (Default Setting)
19200 BPS
19200 bits per second
28800 BPS
28800 bits per second
38400 BPS
38400 bits per second
PROTOCOL
Sets the data flow control (handshaking) method, where:
BOTH
XON/XOFF and CTS/DTR are used. (Default Setting)
SOFTWARE
XON/XOFF is used.
HARDWARE
CTS/DTR is used.
NONE
Flow control is not used.
PARITY
Sets word parity, where:
NONE
Parity is not used. (Default Setting)
ODD
Odd parity is used.
EVEN
Even parity is used.
DATA BITS
Sets word length, where:
7
A seven bit word is used.
8
An eight bit word is used. (Default Setting)
STOP BITS
Sets the number of stop bits, where:
1
One stop bit is used. (Default Setting)
2
Two stop bits are used.
SERIAL PORT D
When equipped with a GPIO Card, this controls the RS-232
communications settings for the COM D (J3) port, as follows:
BAUD RATE
Sets the serial communication rate:
1200 BPS
1200 bits per second
2400 BPS
2400 bits per second
4800 BPS
4800 bits per second
9600 BPS
9600 bits per second (Default Setting)
19200 BPS
19200 bits per second
28800 BPS
28800 bits per second
38400 BPS
38400 bits per second
PROTOCOL
Sets the data flow control (handshaking) method, where:
BOTH
XON/XOFF and CTS/DTR are used. (Default Setting)
SOFTWARE
XON/XOFF is used.
HARDWARE
CTS/DTR is used.
NONE
Flow control is not used.
Summary of Contents for H Class
