PRODUCT REFERENCE GUIDE 13
STEP 6 - X-PRESS CONFIGURATION
Once Matrix 450N has calibrated image density, you can configure it for optimal code
reading relative to your application. This configuration can be performed either through
the X-PRESS Interface or the DL.CODE configuration program.
Locate
Figure 12 - X-PRESS Interface: Locate Function
1. Enter the Focus function by pressing and holding the X-PRESS push button until
the Focus LED is on.
2. Release the button to enter the Focus function. The Blue Diamonds turn on.
3.
Select a code from your application
. Position the code at the center of the FOV
(equidistant from the Blue Diamonds).
4. Exit the Focus function by pressing the X-PRESS push button once. The Diamonds
and laser pointers turn off.
Setup
Figure 13 - X-PRESS Interface: Setup Function
5. Enter the Setup function by pressing and holding the X-PRESS push button until
the Setup LED is on.
6. Release the button to enter the Setup function. The Setup LED will blink until the
procedure is completed.
The Setup procedure ends when the Image Acquisition parameters are successfully
saved in the reader memory, the Setup LED will stop blinking and Matrix 450N
emits 3 high pitched beeps.
If the calibration cannot be reached after a timeout of about 5 (five) seconds
Matrix 450N will exit without saving the parameters to memory, the Setup LED
will stop blinking and in this case Matrix 450N emits a long low pitched beep.
Summary of Contents for matrix 450N
