Datalogic matrix 450N, Reference Manual

Page: 165 / 175

ALTERNATIVE CONNECTIONS
153
A
In order to meet EMC requirements:

connect the reader chassis to the plant earth ground by means of a flat copper braid
shorter than 100 mm;

connect the main interface cable shield to pin K of the 19-pin connector.
MATRIX 450N LIGHTING SYSTEM CONTROL CONNECTOR
Matrix 450N controls the LT-03x series lighting system from this connector through software.
Matrix 450N can also receive power from this input, normally from the LT-03x lighting system
through the CAB-LD-002 cable.
Matrix 450N cannot source power through this
connector .
Figure 78 - M12 8-pin Male Lighting System Control Connector
Matrix 450N M12 8-pin Lighting System Connector Pinout
Pin Name Function
1 SPOT1 Red Spot control signal
2 STROBE Illuminator control signal
3 SPOT2 Green Spot control signal
4 AIMING Aiming Lasers control signal
5 LDA I2C channel data signal
6 LDL I2C channel clock signal
7 GND Power supply input voltage negative
8 VDC (*) Power supply input voltage positive
(*) in the CAB-LD-
102 LT Driver No Power cable, this pin isn’t connected. In this way the
Matrix 450N is powered ONLY from pin A of the M16 19-pin male connector.