Datalogic matrix 450N, Reference Manual, Page: 13 / 175

RAPID CONFIGURATION
1
1
1 RAPID CONFIGURATION
STEP 1
– ASSEMBLE THE READER
The first step to perform is to assemble the accessories that make up the Matrix 450N
reader. The lens and lighting system or external illuminator must be used. This procedure
shows an LT-03x series lighting system.
CAUTION:
Matrix 450N must be disconnected from the power supply during
this procedure.
1. In a dust-free environment, remove the Matrix 450N Lens Cover by unscrewing it.
CAUTION:
Do not touch the sensor aperture, lens glass or lens cover glass.
These areas must be kept clean. Avoid any abrasive substances that might
damage these surfaces during cleaning.
2. Remove the sensor protection label by pulling it off of the base.
3. Mount the LNS-12xx lens by slowly screwing it onto the base until it arrives at the
mechanical stop.
NOTE:
The lens mount is equipped with a special slip mechanism and
together with the LT-03x design facilitates the focusing procedure during
installation, for example if the locking knobs on the lens are obstructed by the
body of the illuminator. See note in Step 4 "Focusing the Reader" or Step 8.
Figure 1
– Assembling Matrix 450N and LNS-12xx Lens
NOTE:
The anti-vibration components are already mounted to all Datalogic
LNS-12xx Lenses.
4. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.
Locking Knobs Lens Cover
anti-vibration components
(see note below)
Protective Film
(remove before calibration)
Matrix 450N Base