RAPID CONFIGURATION
13
1
STEP 7
– TEST MODE
Use a code suitable to your application to test the reading performance of the system.
Alternatively, you can use the Datalogic 1D/2D Test Chart (Code 39, Data Matrix ECC 200).
1. Enter the
Test
function by pressing and holding the X-
PRESS™ push button until the
Test LED is on.
2. Release the button to enter the
Test
function.
Once entered, the Bar Graph on the five LEDs is activated and if the reader starts
reading codes the Bar-Graph shows the Good Read Rate. In case of no read condition,
only the STATUS LED is on and blinks.
green
green
yellow
yellow
red
Figure 12
– X-PRESS™ Interface: Test Function
3. To exit the Test, press the X-
PRESS™ push button once.
NOTE
By default, the Test exits automatically after three minutes.
The Bar Graph has the following meaning:
95%
75%
60%
40%
20%
Figure 13
– Test Bar Graph
Summary of Contents for Matrix 210
Page 1: ...MATRIX 210 Reference Manual...
Page 142: ...www datalogic com...
