Instruction
Manual
DataVS1
Series
51
Now we must perform the ROI positioning and resizing procedures: follow the instructions
provided earlier during this procedure.
We can access the Adjust mode by pressing the
STATUS
button. Let's increase the minimum
position value slightly using the
ARROW UP
button.
Now press the
STATUS
button to enter Monitor Mode and check that the tool functions properly.
The sensor now behaves as required. As the result is satisfying, press
STATUS
again and move
on to defining the behaviour of the outputs.
Let's associate output 1 to the Part Pass behaviour and output 2 to the Error behaviour. Press
TEACH
to save the modifications.
