Select Audio Jingle for Good Read Event
Product Reference Guide
77
Good Read Beep Length — continued
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 0.1 to 25.5 seconds in 100ms
increments. See
Good Read LED Duration on page 238
for more detailed programming
instructions.
Select Good Read LED Duration Setting
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
020 = Good Read LED stays on
for 2 seconds.
NOTE
Indicators are dimmed during sleep.
$CBPLE12
Good Read Beep Length = 180 msec
$CBPLE14
Good Read Beep Length = 200 msec
$CLAGL
~
Summary of Contents for Cobalto C05300
