IF61 Compliance Insert
For Users in the United States and Canada
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may
void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Les utilisateurs de ce produit sont avisés d’utiliser des accessoires et des périphériques approuvés par Intermec Technologies Corporation.
L’utilisation d’accessoires autres que ceux recommandés ou des changements à ce produit qui ne sont pas approuvés par Intermec
Technologies Corporation peuvent annuler la conformité de ce produit et mettre fin au droit qu’a l’usager d’utiliser l’équipement.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to correct the
interference at their own expense.
Canadian Digital Apparatus Compliance
This Class A digital apparatus meets all requirements of the Canadian ICES-003.
Conformité aux normes canadiennes sur les appareils numériques
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Radio Wave or Radio Frequency Maximum Permissive Exposure (MPE)
When installing and using the Intermec IF61 RFID Reader, a 23-cm (9-inch) passing distance must be maintained from any body part of the
user or nearby persons and the RFID reader. The antenna must not be touched during transmitter operation.
Exposition maximale permise (EMP) aux ondes radio ou aux fréquences radio
Lors de l’installation et de l’utilisation du lecteur Intermec IF61, une distance de passage de 23 cm (9 po) doit être maintenue entre l’antenne
RFID et toute partie du corps de l’utilisateur ou des personnes à proximité. Il ne faut pas toucher à l’antenne pendant le fonctionnement de
l’émetteur.
For Users Outside of the United States and Canada
EN 55022/CISPR 22 Compliance
Radio Wave or Radio Frequency Maximum Permissive Exposure (MPE)
When installing and using the Intermec IF61 RFID Reader, a 23-cm (9-inch) passing distance must be maintained from any body part of the
user or nearby persons and the RFID reader. The antenna must not be touched during transmitter operation.
CE Marking:
Refer to the Declaration of Conformity for a list of the EU Directives and Standards that this product complies with.
Caution: This marking indicates that the user should read all included documentation before use.
Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.
Caution: This marking indicates that the user should read all included documentation before use.
Caution: This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
