Manual Datafox Evo 4.6 FleKey
Page 164
Date: 14.09.2021 V 04.03.17.XX
5.14.7.4. Status information on the camera
The device status available from the DatafoxStudio provides information on the number of pictures
recorded by a device and the camera itself. Later will be provided once the camera startup phase
has been completed (see 5.14.7.1).
Section “[RECORD-APPENDIX]” (red marker in
Fehler! Verweisquelle konnte nicht gefunden
erden.
) shows information on the image storage area.
The record storage area has the internal type “Photos”, “Size” shows the total amount of data
(measured in bytes) that can by put into the storage area. The number of images contained inside
the buffer is shown as “Count”.
Section “[CAMERA]” (green marker in
Fehler! Verweisquelle konnte nicht gefunden werden.
)
shows information on the camera.
“Type” details the hardware used as a built-in camera.
“Status” shows state information on the camera. The properties shown here are being reset when
the device
restarts. The first piece of information (here: “Ready”) shows the overall state. The detail
information in braces has the following meaning:
P
count
= Total count of images taken
PS
count
= Count of images recorded by randomized picture recording function.
PC
count
= Count of invocations oft he randomized picture recording function
M
number
= Mode oft he camera as defined by the setup:
o
„0“ = Camera is deactived by the setup,
o
„1“ = Camera is used for simple picture recording,
o
„2“ = Camera is used for simple or randomized picture recording.
RA
number
= If used for simple or randomized picture recording,
number
is the sample
percentage as defined by the setup.
E
count
,
count
= Number of communication errors between terminal and camera module
RE
count
= Count of camera module reboots
The “Info” section contains settings applied. Currently, the resolution
and image format are shown.
Figure 11 Device status with built-in camera
