MA1069 PWRM10-01 & PWRM20-01 Quick Start Guide
Page 10 of 16
Modules are factory configured as follows:
Static IP Address
192.168.128.100
Subnet Mask
255.255.255.0
Gateway
127.0.0.1
DNS Server
8.8.8.8
The Discovery Tool will find multiple modules connected to a network with the same static IP address.
For proper operation, assign each module a unique IP address or change the configuration to DHCP.
To change the settings, hover over a module Device Name in the list and right click to open the
configure network menu.
Figure 11: Change IP Parameters
Click
Change IP Parameters
, then enter the desired static IP address parameters or select DHCP to
allow a network controller to automatically assign an IP address.
Figure 12: Configure IP Parameters
To push network configuration changes to the module, press the
OK
button.
To apply the new network settings, power cycle the module or right click the module again and select
Reset Device
. The module will be removed from the list and reappear when a connection is
established using the new parameters.
