Introduction
96-00290-001 Rev. A1
DataDirect Networks StorageScaler 2460 User Guide | 2
This chapter describes the features of your StorageScaler 2460 enclosure and shows you
how you can upgrade your enclosure as your storage requirements change. It also lists the
contents of the StorageScaler 2460 enclosure kit, and describes additional hardware
requirements.
1.1
Kit Contents
•
DataDirect Networks StorageScaler 2460 enclosure
•
Two power cords
•
Rackmount kit
•
24 Drive Carriers
•
User Documentation CD
1.2
Disk Drive Specifications
The StorageScaler 2460 enclosure supports up to 24-2.5" SAS or SATA disk drives (see
Section
1.6
).
Disk drives must be qualified by DataDirect Networks and meet these specifications:
•
7200, 10,000, or 15,000 rpm
•
Hot-swap/hot-plug support
•
SATA or SAS device plug connector
•
6 Gb/sec or 3 Gb/sec data rate
•
2.5" form factor
•
(
SAS disk drives
) Upgradable disk drive firmware
1.3
Cable Specifications
To connect your StorageScaler 2460 enclosure, use high-quality SAS cables that meet these
length requirements:
•
Minimum length: 0.5 meters
•
Maximum length: 3 meters
NOTE :
The actual cable length supported is determined by the maximum cable
length supported by the HBA used. Refer to your HBA documentation to
verify the maximum cable length supported.
For updated disk drive information or to purchase approved SAS cables, please contact your
DataDirect Networks sales representative.
USO
RESTRITO
