Initial Configuration
20
© 2010 Datacom Systems Inc
VERSA
™
stream
4.3.3 Installing the SFP Module
SFP modules might ship already installed in your FVS or they might arrive packaged separately. This section
describes how to install the SFP module.
NOTE:
You can install SFP modules with power on to the system; however, it is strongly recommended that
you do not install the SFP module with fiber or copper cables attached to it. Disconnect all cables before
installing a SFP module.
CAUTION:
Prevent system problems, use only Datacom Systems Inc. supplied SFP modules.
Step 1.
Turn the SFP module so the latch is towards the center of the Gigabit Ethernet Interface sockets. The
SFP module is keyed so that it cannot be inserted incorrectly.
Step 2.
Insert the SFP module into the SFF port and repeat
Step 1
and
Step 2
inserting other SFP modules
until completed.
Step 3.
Attach the appropriate network cable to the LC-type or RJ45-type connector on the SFP module. For
fiber optic SFP modules you can use either simplex or duplex connectors. For simplex connectors, two cables
are required, one cable for transmit (Rx) and a second cable for receive (Rx). For duplex connectors, only one
cable that has both Tx and Rx connectors is required.
4.3.4 Removing the SFP Module
SFP modules might ship already installed in your FVS or they might arrive packaged separately. This section
describes how to remove the SFP module.
NOTE:
You can remove SFP modules with power on to the system; however, it is strongly recommended that
you do not remove the SFP module with fiber or copper cables attached to it. Disconnect all cables before
removing a SFP module.
Step 1.
Disconnect the network cable from the SFP module LC-type or RJ45-type connector.
Step 2.
Release the SFP module from the GE SFF port by moving the swing latch away from the body of the
unit.
Step 3.
Slide the SFP module out of the GE SFF port.