Initial Configuration
18
© 2010 Datacom Systems Inc
VERSA
™
stream
Prior to proceeding any command line entry, observe the following serial startup screen activity that will last for
approximately one and a half to two minutes:
DipSwitch Status = 0xFF
Enabling Datacom RS232 serial port.
Datacom Systems, Inc. FVS-1080
Starting Self Tests.....
Memory Tests Pass!
Located Datacom 512MB DDR
*
*
*
Booting Operating System.....please wait.....
VERSAstream Initialization In Process....
Restoring Settings...
VERSAstream Active
...
The FVS is now ready to accept command line entry commands.
Step 6.
Hit the
Enter
key twice in succession (i.e.,
Enter
,
Enter
) to display the
username:
prompt. The CLI
username and password are case-sensitive. The default values are:
username: Administrator
password: admin
>
?
and press the
Enter
key to see available commands list, details in '
Basic Command Set
' section.
Step 7.
Separate IP, Subnet or Gateway CLI entries
ARE NOT ALLOWED
for the
FVS-1080
. '
Set IP
Address
' by typing
SET IP ppp.ppp.ppp.ppp sss.sss.sss.sss ggg.ggg.ggg.ggg
where ppp.ppp.ppp.ppp
corresponds to a valid IP address, where sss.sss.sss.sss corresponds to a valid SUBNET for your network and
where ggg.ggg.ggg.ggg corresponds to a valid GATEWAY for your network. Press the
Enter
key to continue.
Step 8.
Review and verify the network address settings are correct and enter (
y
) to confirm changes (updating
elapsed time approximately 15 seconds) otherwise enter (
n
) to cancel and repeat Step 7.
Step 9.
Follow the screen prompts and at the command prompt, type '
REBOOT -management
'
to allow the
new network setting to take effect.
Step 10.
Follow the screen prompts and after the screen response
VERSAstream Active . . .
(elapsed time
approximately 35 seconds) type '
SH MA
'
to review the network address settings. Verify settings are correct.
Step 11.
Type '
EXIT
' and press the
Enter
key to end the connection session indicated by 'Closing
Connection . . . ' response, then close the terminal emulation application.
Step 12.
Disconnect the DRL512-2M-R serial cable from your FVS series product and proceed to install the
FVS series product in your chosen network location.
73
78
83
76
83