Data Flow Systems TCU800, Quick Start Manual

Page: 18 / 25

17
Configuration Settings
Grouped configurations are found on the Settings screen. The following is a table with the locations of each
configuration. For further explanation of a configuration, refer to the TCU001 manual unless otherwise
indicated.
Settings
Analog Main Settings TCU Settings Radio
High Number of Pumps IP Address Station
Lag 2 On Level Pump Mode Subnet Data Invert
Lag 2 Off Level Transducer Type DNS Data Swap
Lag 1 On Level Alternator Type Gateway Tx Invert
Lag 1 Off Level Minimum Run Time Home Screen Rx Invert
Lead On Level Minimum Off Time Display Touch Gestures Async Baud
Lead Off Level Start Fault Alarm Debug Logging Dash Number
Flow EQ Stop Fault Alarm GBL MOD DLY
Low Level Auto Retry GBL FIX DLY
XDCR 2 Low Cal Point BEM Modules GBL STA DLY
XDCR 2 High Cal Point Trend Rate Rad PGM
XDCR 1 Low Cal Point
XDCR 1 High Cal Point
Fault Mode
XDCR Low Level
Fault
Auxiliary Alarm Outputs Phase Monitor Floats
Aux Output Turns Alarm Horn Range High Float
Delay After Alarm Light Low Alarm Low Float
Aux Input Turns High Alarm XDCR High Float Fault
Aux Input Alarm High Float Override
Aux Alarm
Moving the H-O-A switches to Auto at any point while in the Settings or Advanced Settings screen will
terminate the session and return to the last viewed screen without saving any changes.