19
Radio Test Mode
Allows for test messages to be sent during installation to
test antenna signal. Allows for keying of radio, and
viewing network traffic.
Reset Pump Statistics
Reset all pump statistics at once.
Calibrate PMA
Fine tune PMA chip. This should not have to be done
once installed.
Time
Manually configure internal clock.
Device Manager
Currently supports writing all station statistics and
configurations to the Configuration USB. If a USB device
is connected and has not been formatted as a
Configuration USB, it will ignore it.
For detailed instructions for integrating the TCU with your telemetry system, see the
TCU800 Installation
and Operation Manual
.
Touchscreen-invoked Functions
Detailed information on these functions can be found in the
TCU800 Installation and Operation Manual
.
View process ID and version level
Swipe to the Settings page. Select About > Software. This tab
contains the operating system version, serial number, PLC
version, and package version.
View serial number, station address,
radio configuration, and firmware
version
Swipe to the Settings page. Select About > Station. This tab
contains the station address and the radio configuration
Place TCU in radio test mode
Swipe to the Settings page. Select Advanced Options > Radio
Test Mode.
Key radio and measure antenna
reflective power
Place the TCU in radio test mode (see box above). Select the
KEY button to force a radio transmission.
Auto download TCU configuration
Swipe to the Settings page. Select Advanced Options > Auto
Configuration.
Summary of Contents for TCU800
Page 1: ...T C U 8 0 0 Q u i c k S t a r t G u i d e Data Flow Systems Inc...
Page 23: ...22 Notes...
Page 24: ...23 Notes...
