V1.0
23
Consecutively press
Menu/Exit Key
until the LCD shows [Quit the
Menu]. Then press
Set Key
to return to Normal Mode, as shown
below.
Set Key
must be pressed to save the newly changed value.
Directly pressing
Menu/Exit Key
or switching off the
laminator will not save any newly changed value(s).
3.3 Major Menus
Version Info
Lamination Info
Laminate Parm Setup
Laminator Setup
Interface Setup
Reset Default
Version Info
Main Version
：
Version number of Main Firmware.
Main Boot
：
Version number of Main Boot.
Laminator Info
Card Count
：
The total number of Cards passed
through the Laminator.
Total Count
：
The total amount of Laminates applied.
Serial Number
：
Laminator SN.
Model ID
：
Model ID.
Setup
Ready to Laminate
Quit the Menu ?
YES
Summary of Contents for DC-5100
Page 1: ...User Manual DC 5100 Laminator ...
Page 22: ...V1 0 11 laminator on the left side is the rewind pole Put 2 spool covers back in place ...
Page 24: ...V1 0 13 2 2 Loading the Card Load the card through the slot one at a time ...
Page 26: ...V1 0 15 Parameter setting item Parameter list Parameter annotation ...
